01782 432609
 077537 406 61

Show me / Tell me - effective from 4th Dec 2017

Changes to the driving test take effect on the 4th Dec 2017. If you will be taking your driving test on or after this date then you should refer to the new set of show me / tell me questions below


'Tell me' questions

Q1
Tell me how you would check the brakes are working before starting a journey
Show me tell me Question 1

CLICK IMAGE TO REVEAL RESPONSE

Brakes should be tested as you set off by applying gentle pressure at slow speed. Brakes should not feel spongy or slack and the vehicle should not pull to one side.
Q2
Tell me where you would find the information for the recommended tyre pressures for this car and how tyre pressures should be checked
Show me tell me Question 2

CLICK IMAGE TO REVEAL RESPONSE

Recommended pressures can be found In the manufacturer's guide. Use a reliable pressure gauge, check and adjust pressures when tyres are cold, don’t forget spare tyre, remember to refit valve caps.
Q3
Tell me how you would check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road
Show me tell me Question 3

CLICK IMAGE TO REVEAL RESPONSE

Tyres should be checked to ensure there are no cuts or bulges. There should be 1.6mm of tread depth across the central ¾ of the breadth of the tyre and around the entire outer circumference. This can be checked with a tyre depth guage or the depth markers in the tyres themselves.
Q4
Tell me how you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash
Show me tell me Question 4

CLICK IMAGE TO REVEAL RESPONSE

Adjust the rigid part of the restraint so that it is close to the back of your head and level with your eyes or top of your ears.
Q5
Tell me how you would check that the headlights & tail lights are working
Show me tell me Question 5

CLICK IMAGE TO REVEAL RESPONSE

Turn on the relevant switch and walk around the car checking that they are working,
Q6
Tell me how you would know if there was a problem with your anti-lock braking system
Show me tell me Question 6

CLICK IMAGE TO REVEAL RESPONSE

The ABS warning light would become illuminated on the instrument panel if there is a fault.
Q7
Open the bonnet, identify where you would check the engine oil level and tell me how you would check that the engine has sufficient oil
Show me tell me Question 7

CLICK IMAGE TO REVEAL RESPONSE

Identify dipstick/oil level indicator, describe check of oil level against the minimum/maximum markers.
Q8
Open the bonnet, identify where the brake fluid reservoir is and tell me how you would check that you have a safe level of hydraulic brake fluid
Show me tell me Question 8

CLICK IMAGE TO REVEAL RESPONSE

Identify reservoir, check fluid level is between high/low markings.
Q9
Open the bonnet, identify where you would check the engine coolant level and tell me how you would check that the engine has the correct level
Show me tell me Question 9

CLICK IMAGE TO REVEAL RESPONSE

Identify high/low level markings on header tank where fitted or radiator filler cap and describe how to top up to correct level.
Q10
Tell me where the windscreen wash reservoir is and how you would check the level.
Show me tell me Question 10

CLICK IMAGE TO REVEAL RESPONSE

Explain how the washer fluid should be filled to a level between the min and max markers on the side of the reservoir. They can be checked by simply operating them.

'Show me' questions

Q11
Show me/explain how you would check that the power assisted steering is working before starting a journey
Show me tell me Question 11

CLICK IMAGE TO REVEAL RESPONSE

If the steering becomes heavy the system may not be working properly. Before starting a journey two simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.
Q12
Show me how you would check the parking brake (handbrake) for excessive wear, make sure you keep control of the vehicle
Show me tell me Question 12

CLICK IMAGE TO REVEAL RESPONSE

Apply footbrake firmly. Demonstrate by applying parking brake so that when it is fully applied it secures itself and is not at the end of the working travel.
Q13
Show me how you would check that the horn is working (off road only)
Show me tell me Question 13

CLICK IMAGE TO REVEAL RESPONSE

Check is carried out by pressing gently on the control (turn on ignition if necessary).
Q14
Show me how you would check that the direction indicators are working
Show me tell me Question 14

CLICK IMAGE TO REVEAL RESPONSE

Applying the indicators or hazard warning switch and check functioning of all indicators. You may need to switch the ignition on, however, you should not start the engine.
Q15
Show me how you would check that the brake lights are working on this car (I can assist you, if you need to switch the ignition on, please don’t start the engine)
Show me tell me Question 15

CLICK IMAGE TO REVEAL RESPONSE

Operate brake pedal, make use of reflections in windows, garage doors, etc, or ask someone to help. As this is now a show me question the examiner may check the brake lights for you. You may need to switch the ignition on, however you should not start the engine.
Q16
Show me how you would clean the windscreen using the windscreen washers and wipers
Show me tell me Question 16

CLICK IMAGE TO REVEAL RESPONSE

Operate control to wash and wipe windscreen. You may need to switch the ignition on, however, you should not start the engine.
Q17
Show me how you would set the demister controls to clear all the windows effectively, this should include both front and rear screens
Show me tell me Question 17

CLICK IMAGE TO REVEAL RESPONSE

Set all relevant controls including: fan, temperature, air direction/source and heated screen to clear windscreen and windows. Engine does not have to be started for this demonstration.
Q18
Show me how you would switch on the rear fog light(s) and explain when you would use it/them (no need to exit the vehicle)
Show me tell me Question 18

CLICK IMAGE TO REVEAL RESPONSE

Operate the rear fog switch after switching on dipped headlights, check switch is illuminated and explain that they should only be used when visibility is reduced to 100 metres or less.
Q19
Show me how you switch your headlights from dipped to main beam and explain how you know the main beam is on whilst inside the car.
Show me tell me Question 19

CLICK IMAGE TO REVEAL RESPONSE

Move the stalk attached to the steering column forwards which will illuminate a blue warning light on the instrument panel.

Printable PDF version


In2Gear driving school providing driving lessons by a fully qualified driving instrucor in Stoke on Trent, Newcastle, Fenton, Hanley, Tunstall, Burslem, Meir, Longton, Kidsgrove, Congleton, Audley, Cheadle, Leek and all ST postcodes!
go to top of page